Pneumatic

Tecno basic

Tecno basic · PRE-U / PRE-I

In Stock

Tecno basic combines a piezo pilot with electronic closed-loop pressure control in 0-0.2, 0-2 and 0-8 bar variants. Choose voltage control or a 4-20 mA two-wire current loop. The PS120006 voltage version adds 0-10 V pressure feedback. Flow, input range and wiring depend on the selected variant.

Contact Now Return to Products

Features

0-0.2 / 0-2 / 0-8 bar variants
Voltage setpoint or 4-20 mA two-wire loop
PS120006 provides 0-10 V pressure feedback
Low-power piezo pilot; G1/8 base plate

General specifications

SeriesPRE-U / PRE-I

Voltage model branchesPS120000 / PS120006

Current model branchPS120001

Voltage-model power supply24 V DC ±10%

Voltage-model maximum nominal power / current0.4 W / 15 mA

Current-model maximum input voltage12.5 V

Pressure feedback (PS120006)0-10 V; ≤1 mA

Base plate ports / boreG1/8 / 2.5 mm

ProtectionIP30

Ambient / medium temperature0…+50 °C

Storage temperature-20…+60 °C

Mass (valve / with base plate)0.100 / 0.155 kg

↔ Swipe horizontally to view all specifications

Pressure variants
Pressure code	Output pressure	Supply pressure p1	Maximum flow Qmax	Repeatability	Linearity
002	0-0.2 bar	1.5-2.5 bar	70 L/min	<0.5%	<1.0%
020	0-2 bar	1.5-7 bar	200 L/min	<0.2%	<0.5%
080	0-8 bar	1.5-10 bar	350 L/min	<0.2%	<0.5%

↔ Swipe horizontally to view all specifications

Electrical variants
Model branch	Setpoint input	Power supply	Pressure feedback	Connector
PS120000	080: 0-8 V; 002/020: 0-10 V	24 V DC ±10%	None	M8, 3-pin
PS120006	080: 0-8 V; 002/020: 0-10 V	24 V DC ±10%	0-10 V	M8, 4-pin
PS120001	4-20 mA	Two-wire loop powered	None	M8, 3-pin

Conditions and selection notes

Repeatability, hysteresis and linearity are relative to the maximum output pressure p2max of the selected variant. Linearity is specified at +20 °C.
The 0–8 bar version has a nominal flow of 200 L/min. Select each pressure variant for the operating pressure differential and required flow.
The 0–8 bar version has a maximum flow of 350 L/min at p1 = 10 bar, p2 = 6.3 bar and Δp = 1 bar. Actual flow depends on supply pressure, output pressure and load. Distinguish nominal flow from maximum flow when selecting the valve.
PS120001 is powered by the two-wire loop; input voltage must not exceed 12.5 V. Do not apply 24 V directly as for a voltage-controlled model.
Example PS120006-020: 0-2 bar output, 0-10 V setpoint and feedback, maximum flow 200 L/min. Control gain can be adjusted using programming kit PS12423-A.
Supply pressure must be at least 1 bar above the highest required output pressure and within the limits of the selected variant. Use clean compressed air meeting the model requirements and keep exhaust ports unobstructed.